How to's
Dunlop Air Suspension - Fitting Made Easy
Dunlop Air Suspension, fitting made easy guide
Member Techno100 has produced the following information about self fitting Dunlop Air Suspension:
For this job you will need:
- Some additional ground clearance (Milenco Quattros ideal)
- A long handled torque wrench
- Hammerite Waxoyl to coat all metal parts during assembly
- A tape measure for LSV (load sensing valve)
- 1/2" drive sockets 13,17,22mm
- Hammer, cold chisel, sidecutters, stanley knife, battery drill, 8mm HSS bit
Begin with the rod measurement at the LSV as this may alter with the suspension upgrade and need to be adjusted later, BEFORE driving.
Most Popular How to's
How to's
740
Firstly - what is a web-app? Proper name is Progressive Web App, commonly known as app or web-app....
How to's
295
Does your cassette leak when its full? Or when you upturn it to carry to a disposal point? A short...
How to's
443
Van security - Fitting Thule External Locks There are lots of ways to protect your motorhome from...
How to's
445
Van security - Fitting Proplates There are lots of ways to protect your motorhome from thieves and...
How to's
2079
Website vs App I've been asked on numerous occasions whether we have an app? Well I hope this...
How to's
3028
Fancy a free DIY tracker? If you’ve been in the mobile phone world long enough, you might well...
How to's
3952
I've been using a Towtal A-Frame with a RVi2 Electronic braking system for a few years now. This...
How to's
5953
Old Soldier's Guide for Newbie Chuggers Admin Note: Club Motorhome member 'Old Soldier' has kindly...
How to's
21133
If your water pump pulses frequently it's quite likely it has a leak or is drawing air into the...
(share) button at the bottom of your screen,
( Add to Home screen ).
